10” Cabinet Saw Sliding Table Model: 10-110B/E Owner’s ManualFor more information:www.rikontools.com or [email protected] Part
Carriage Table Support Arm Installation1. Insert the support arm into the swing arm extension bar as shown (A, Fig. 9) making sure that bearing assemb
11Installing the Sliding Table Miter Fence1. Locate the miter fence (A, Fig. 13) and miter fence locking knob (B, Fig. 13) as shown. 2. Lay the miter
12Figure 17Installing the Sliding Table Locking Pin1. Locate the locking pin with the black handle and thread it through the sliding table body with w
13Locking and Unlocking the Slide Table Keep the sliding table locked when not in use. Failure to do so could cause serious inj
Cutting Sheet Goods1. Adjust the hold down plate according to the width of material to be cut.2. Lay the workpiece onto the table and up against the s
15 BEFORE CLEANING OR CARRYING OUT MAINTENANCE WORK, DISCONNECT THE MACHINE FROM THE POWER SOURCE (WALL SOCKE
16FOR YOUR OWN SAFETY, ALWAYS TURN OFF AND UNPLUG THE MACHINE BEFORE CARRYING OUT ANY TROU-BLESHOOTING.For parts or technical questions contact: techs
17Parts Diagram
18Parts ListKey No.1E2E3E4E5E6E7E8E9E10E11E12E13E14E15E16E17E18E19E20E21E22E23E24E25E26E27E28E29E30E1F2F3F4F5F6F7F8F9F10F11F12FPart No.1-JL822360091-J
192-Year Limited WarrantyRIKON Power Tools/Richen Enterprise, Inc. (“Seller”) warrants to only the original retail consumer/purchaser of our products
IMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following in-structions must be followed at all t
For more information:110 Cummings ParkWoburn, MA 01801877-884-5167/781-933-8400techsupport@rikontools.comwww.rikontools.comCopyright Richen Enterpris
ALWAYS CHECK FOR DAMAGED PARTS.Before initial or continual use of the tool, a guard or other part that is damaged should be checked to assure that it
Safety Warnings...
5Model 10-110B/E 10” Table Saw Sliding Table is shipped complete in 2 boxes.Unpacking and Checking ContentsSeparate all “loose parts” from packaging m
6TABLE OF LOOSE PARTSItem Part Name QtyA Swing Arm Assembly 1B Swing Arm Extension Bar 1C Sliding Table Carriage 1D Sliding Table Support A
7Getting To Know Your Sliding Table1. Flip Stop2. Miter Fence3. Sliding Table4. Sliding Table Locking Pin5. Push Block6. Slide Handle7. Swing Arm Asse
8Mounting the Swing Arm Bracket1. Open the motor cover located at the left side of the saw.2. With assistance hold the swing arm bracket against the s
9Mounting the Sliding Table Continued3. Slide the hardware toward the cast mounting bracket located on the saw body. Place the adjusting plate on top
Comments to this Manuals