Rikon Power Tools 10-110B Owner's Manual

18” Woodworking BandsawModel: 10-345 Owner’s ManualFor more information:www.rikontools.com or [email protected] Parts or Questions:techsupport@r

10Figure 9Figure 10Figure 11Figure 12ACBABCDAdjusting the Blade GuidesUpper Guides: To adjust the upper blade guides, rst position the roller guides

11Changing the Blade Speed / Belt Tension WARNING! Before changing the speed, always make sure the machine has been unplugged from the electrical s

12Re-sawingFor re-sawing, attach the 3/8” x 3” post to the slot on the fence. Position the re-saw bar so that it is aligned with the front of the blad

Eletrical RequirementsIn the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the ris

14220V Motor Wires BEFORE CLEANING OR CARRYING OUT MAINTENANCE WORK, DISCONNECT THE MACHINE FROM THE POWER SOURCE (WALL SOCKET).

FOR YOUR OWN SAFETY, ALWAYS TURN OFF AND UNPLUG THE MACHINE BEFORE CARRYING OUT ANY TROUBLESHOOTING.15TROUBLEThe machine does not work when switched o

Adjusting the Upper Blade Guide Bearings Parallel to the Blade (Refer to page 19 parts diagram) This step may not be necessary, it is factory preset.

17Parts Diagram

18Parts Diagram

19Parts Diagram

Operator Safety: Required ReadingIMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following instr

203456891011121315161718192021222324262729303132333435363738394041424344454647484950515253545556575859606162636465661-JL26030017A1-M12GB825Z1-JL260110

211371381431441451461491501511521531541561571581591601611621631641651661671681691701711721761-WSH5GB96D12-JL26043000C1-JL260410021-BRG80201GB2781-JL26

22

WARRANTY232-Year Limited WarrantyRIKON Power Tools Inc. (“Seller”) warrants to only the original retail consumer/purchaser of our products that each p

For more information:16 Progress RdBillerica, MA 01821877-884-5167/978-528-5380techsupport@rikontools.comwww.rikontools.comCopyright RIKON Power Tool

ALWAYS CHECK FOR DAMAGED PARTS.Before initial or continual use of the tool, a guard or other part that is damaged should be checked to assure that it

418-3/8” (467 mm)12” (305 mm)142” (3607 mm)1/4” – 1-1/4”(6-32 mm)21”x 19” (534 mm x 483 mm)Left-10o Right-45 o1510 ft/min or 3220 ft/min2.5 HP112203

5Model 10-345 18” Bandsaw is shipped complete in one box. Unpacking and Checking Contentsa. Separate all “loose parts” from packaging materials and

6List of loose parts in the box marked “G”Loose Parts List

7A. Hoist RingB. Tension Indicator WindowC. Blade Tension Hand-WheelD. SwitchE. Rip FenceF. Speed Hand-WheelG. Blade GuideH. Guide Post Hand-

Figure 1Figure 48ABFigure 2Figure 3The 10-345 Bandsaw is supplied partly assembled. Prior to use, the following items have to be assembled: working ta

Figure 5Figure 6Figure 7Figure 89Setting the Table Square to Saw BladeThe table may be set at 90° to the saw blade sides by adjusting the table stop s