Rikon Power Tools 25-010H Owner's Manual download pdf (Page 11)

ASSEMBLY

FIG. 13

FIG. 12

OUTFEED TABLE INSTALLATION

THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH

MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.

1. Position the outfeed table onto the left end of the ma-

chine frame. The two Setting Brackets (#158) fit over the

pre-installed Pan Head, Location Screws (#160) on the

frame for positioning, and then lock the table in place with

the Levers (#233, 234). FIG. 12 & 13.

2. See page 12 for instructions on adjusting the table.

JOINTER FENCE INSTALLATION

1. The Fence Carrier Support Bracket (#240, FIG. 14, A)

has been pre-installed onto the rear side of the infeed table.

2. Slide the Fence Assembly onto the Fence Bracket and

the secure it in position with the Ratchet Lever (#217).

3. See page 13 for instructions on adjusting the fence.

FIG. 14

ADJUSTMENTS

Continued on page 12

JOINTER TABLE ALIGNMENT

For the best surfacing of workpieces, the jointer’s infeed

and outfeed tables must be set at the same level to form a

large ‘ at’ surface. These tables must also be in alignment

with the cutterhead for true surfacing, when you measure

the  atness of a board from side-to-side and end-to-end.

The machine has been factory set before shipping - the in-

feed table being set to the cutterhead knives, and then the

outfeed table set to the infeed table. But once the machine

has been set in its  nal location in the shop, the table align-

ments should be checked to make sure that there has been

no movement during its handling.

LOCKING LEVERS

SETTING BRACKETS

LOCATION SCREWS

RATCHET LEVER

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Rikon Power Tools 25-010H Owner's Manual Page 11